Skip to main content

Battery replacement

Required batteries:

DT510

1Pcs. CR2

EFL30

2Pcs. AAA

DT600

2Pcs. AA

other Types

4Pcs. AA

Required opening tools:

DT7xx

SW-3 with stud

DT600

2,5er hex key

DT400, DT200

3er hex key

DT100

3er hex key,
corresponding opening tool

DT510, LockerLocks

corresponding opening tool

Doorterminals

DT100

  1. Loosen the grub screws on the door handle on the outside of the terminal.
  2. Place the opening tool with the two magnets on the top of the terminal so that the plastic lip snaps into place behind the fitting.
  3. Use the opening tool and the necessary force to pull the fitting forward so that the upper part of the fitting comes loose.
  4. Lift the lower part of the fitting slightly and pull it off.
  5. Replace the batteries one at a time.
  6. Replace the fitting and press down lightly to snap it into place.
  7. Now press down firmly on the upper part of the fitting so that the magnets engage again and the fitting is securely in place.
  8. Screw the door handle back on tightly.

DT210/DT400

  1. Loosen the screw on the door handle and on the underside of the inside of the fitting.
  2. Lift the fitting up briefly and pull it forward.
  3. Replace the batteries one at a time.
  4. Ensure that the DND bolt is in the upright position, otherwise the fitting will not sit correctly.
  5. Replace the fitting. Make sure that the hook on the inside of the fitting clicks into place when replacing it.
  6. If there is no gap at the top or bottom of the terminal and the fitting is firmly in place, the fitting is correctly positioned.
  7. Tighten both screws again.

DT510

  1. Secure the cap using the removal tool.
  2. Place the ratchet with the open side (open lock symbol) facing upwards and unscrew the cap.
  3. Remove the cover and knob from the cylinder.
  4. Remove and replace the battery using the white flag.
  5. Press the black rubber sealing ring firmly into place.
  6. Place the electric knob on the socket. Pay attention to the positioning of the thick and thinner tabs on the knob.
  7. Put the hood on. Pay attention to the guide rails inside the hood.
  8. Screw the knob on lightly so that the hood does not slip.
  9. Secure the cap using the removal tool.
  10. Place the ratchet with the locking side (symbol of the locked lock) facing up and screw the cap tight.

DT600

  1. Loosen the screw on the underside of the outside of the terminal in the hole in the black plastic cover.
  2. Pull the cover downwards to remove it.
  3. Replace the batteries inside.
  4. Replace the cover and screw it back on.

DT7xx

  1. Remove the black round rubber piece located on the top of the inside of the cover.
  2. Loosen the screw underneath and lift the cover.
  3. Replace the batteries one at a time.
  4. Replace the cover, tighten the screw, and put the rubber piece back on the cover.

Furniture terminals

EFL30

  1. Slide open the battery compartment cover.
  2. Replace the batteries inside.
  3. Replace the battery compartment cover.

LockerLock

  1. Place the removal tool on the battery compartment cover.
  2. Remove the battery compartment.
  3. Replace the batteries inside.
  4. Replace the battery compartment.

DG1 (Dialock Generation 1), DG2 (Dialock Generation 2)